Looking for Winchester 69A firing pin spring
 

Hello,

Just want to know where can I buy the firing pin spring for my rifle? I google it seems to be everybody is out of stock.

Re: Looking for Winchester 69A firing pin spring
 

G'day buster they aint that hard to retension if its just become slack or to make one from scratch

Re: Looking for Winchester 69A firing pin spring
 

Jack404 is correct!

Re: Looking for Winchester 69A firing pin spring
 

http://www.gunsprings.com/Rifles%20%.../mID120/dID332

The link above is to Wolf Springs.

The Winchester 75 and 69 used the same basic bolt. Thus the spring may (should) be the same. I would call Wolf before ordering.

If the above does not solve your problem and you have a worn out, but not broken spring; you can stretch it a bit, and then heat treat it and temper it again. The foregoing does require more metalworking knowledge and skill than is possessed by the general population. However, you can likely find directions on the Internet.

Hope this helps.

Re: Looking for Winchester 69A firing pin spring
 

Thanks!