The Firearms Forum - Gun Community

The Firearms Forum - Gun Community (http://www.thefirearmsforum.com/index.php)
-   Black Powder Shooting / Muzzleloaders / Handguns (http://www.thefirearmsforum.com/forumdisplay.php?f=17)
-   -   Cleaning My Rifle (http://www.thefirearmsforum.com/showthread.php?t=113502)

jpg5324 09-15-2012 08:46 PM

Cleaning My Rifle
 
I have and shoot a .45cal Penn Long Rifle....I use Hoppe's #9 to clean it.
I read some where that this is not the right cleaner to use. So can anyone tell me what is the right cleaner???? I use Pyrodex:confused::confused:

jack404 09-15-2012 08:49 PM

Re: Cleaning My Rifle
 
hot water a drop or 6 of lemon fresh detergent ( remove all the old oil and muck) and water ( hot ) rinse and my brushes always works for me

dry with hot air blower ( travel hair dryer) and SBGO well including the touch hole or nipples

Buffalochip 09-15-2012 09:06 PM

Re: Cleaning My Rifle
 
Jack is right, hot soapy water and a stiff bronze brush if it is really dirty. The Hoppes #9 is for smokeless powder firearms, not black powder or Pyrodex. Best to remove the barrel, stick the breech end in a bucket of hot water, dump some dish detergent down the barrel and run a bronze brush down it a few times to knock out the crud and then use a bore swab to pump water in and out of the nipple (or vent hole if flintlock) until the water runs clean. The pour boiling water down the barrel to rinse it out well. The barrel should then be super hot and will dry itself when stood on end. (Aussies use hairdryers, but then they also wear those odd hats and talk funny.) When it is dry, run an oily patch down the barrel to keep it from rusting.

jack404 09-15-2012 09:43 PM

Re: Cleaning My Rifle
 
i use a hair dryer cause the dust here is iron oxide 10 mins in the sun will dry it but that iron dust starts rust in 3 seconds flat , so i do it in the bathroom where its pretty dust free

i aint got enough hair to use it for anything else but parts drying ;)

if you have a red dust problem watch it red in nature is iron

Hawg 09-16-2012 02:56 AM

Re: Cleaning My Rifle
 
If you use a petroleum based gun oil in the bore after cleaning you will need to swab it all out before you load it. If you use a vegetable based oil popping a cap is usually all you need to do. I usually fire a blank charge before loading just to make sure there's no oil left.

howlnmad 09-16-2012 07:59 AM

Re: Cleaning My Rifle
 
Take it in the shower with you and then dry the hell out of it and oil it up.

flintlock 09-16-2012 08:24 AM

Re: Cleaning My Rifle
 
Hot soapy water and a brush or tight fitting jag and patch will do get the fouling out. Hoppes does make a black powder solvent, and on the occasions I have used it, it works pretty well. But you will go through a large batch of patches. I generally let the barrel air dry, heat of the water used to clean it generally make the tube hot enough to dry. then I run a greased patch down the barrel, and oil the outside. Past experience has taught me not to do this in the kitchen sink or the bath tub. I love the smell of black powder, my wife has other opinions!

Twicepop 09-16-2012 09:57 AM

Re: Cleaning My Rifle
 
At the black powder club that I used to belong to, several of the long time members used a solution of distilled water and Windex. Take a gallon of distilled water and pour out enough of it to be replaced with the contents of a bottle of Windex and there you have it. They all swore this was better than anything else they've tried.

those who beat their guns into plowshares, will plow for those who didn't

Hawg 09-16-2012 06:02 PM

Re: Cleaning My Rifle
 
Windex without ammonia.

old semperfi 09-21-2012 09:56 PM

Re: Cleaning My Rifle
 
i use windex with lemon,however i use 777 powder which is water soluble.i also to what i call a max clean up using boiling soapy water and a mop.you must use heat gloves but it dries almost immediatly. old semperfi


All times are GMT -5. The time now is 02:41 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2013, vBulletin Solutions, Inc.
Copyright ©2002 - 2013, TheFirearmsForum.Com