The Firearms Forum - Gun Community - View Single Post

Evins74s · 04-23-2012, 09:26 PM

When I bought my LEE single stage kit I knew that the powder measure wasn't going to be the greatest. SO....I am looking at upgrading my powder measure. I am reloading .40s&w, .223 and .308. I am using H335, CFE223, H4895 and Varget. My current P/M does just fine with Varget since it is not fine like the CFE223. But when I use the CFE223 some of the powder will spill out and end up on my work table or makes it very hard to operate the handle. I am looking at the RCBS and Hornady P/M's but not sure which one is going to work best with the powders I am using. Any input is appreciated.

04-23-2012, 09:26 PM	#1
Evins74s V.I.P. Member Join Date: Dec 2011 Location: Kansas Posts: 96	Need some advice on a powder measure When I bought my LEE single stage kit I knew that the powder measure wasn't going to be the greatest. SO....I am looking at upgrading my powder measure. I am reloading .40s&w, .223 and .308. I am using H335, CFE223, H4895 and Varget. My current P/M does just fine with Varget since it is not fine like the CFE223. But when I use the CFE223 some of the powder will spill out and end up on my work table or makes it very hard to operate the handle. I am looking at the RCBS and Hornady P/M's but not sure which one is going to work best with the powders I am using. Any input is appreciated. -->