Re: more .223 rem qiestions?
Quote:
|
The generic way is to raise the ram, screw the die into the press until it touches the shell holder, lower the ram and screw the die in 1/4 turn more.
|
No...At most there should just be contact with shell holder and die adding this addition 1/4 turn will be too much shoulder setback, and unecessary strain on your die and press. My .223 setup achieves correct headspace with a few thousands gap between shellholder and die...same goes with .308.
__________________
"Democracy is based on citizenship- perhaps the greatest gift the United States has given to the world- Power is vested in the people themselves, and government flows from the people" James M Henslin
|