I hate when that happens!!
I had a reply all set to go ...... Now I cannot find it. It was about 4 hours ago. Oh Well.
Summarizing ............ I did a lot of sorting of brass. In checking necks of all my empty brass with a bullet..... Only 25 out of about 130 cases had an easier "slip in about 1/8" fit".
The rest were all what "should be".
All cases were trimmed, deburred, and ready to go for powder and bullets.
I am starting from scratch
and am going to do the Load Development Ladder Test by JLA as posted at the start of this forum.
I can't get out till next week but I will post some results.
Again ...... I read and studies ALL the replies and THANK YOU!!