[larrydickman]

I was loading some 9mm and toward the end the seating die started to pull the bullet back out of the case. I had to remove the die and get the bullet out, this happened several times. I am not sure if it is just dirty, the bullets are 115 grain and they had been loaded already and I used a kinetic bullet puller to remove the bullet. The load was a bit too low and would not cycle the guns properly. So I reloaded them with a bit more powder. Would this be because of pulling the bullet? I rebelled the case and added the new powder charge but then when seating the bullet some would pull out and jam in the die. Any help app. Thanks