Re: herters press and powder measure
Originally Posted by howlnmad
You can easily fabricate a mounting bracket like the one that comes with the RCBS uniflow. A piece of flat steel or alum 1 1/4 wide by 6 inches long. Drill a 7/8 inch hole in one end and 2 smaller holes in the other. Mount it to a shelf or bench with the small holes. Use 2 die lock nuts to fasten the measure in the large hole.
I may have to go that route. how thick should the steel be? 1/4" or is 14g enough?
I'll go defenseless when our leaders do the same
Obama likes to speak softly on his free cell phone and carry a big pen. Heil Obama!!