WELL!!!! todays latter test did not go as expected.
I made up the 20 target chart just like JLA did in his thread, but I used 1" black adhesive circles for the bullseye. No problem I thought as I look at the target. (Boy was I wrong
) Got to the range and set up the target on the 100 yard range, went back to the firing line. Here are my gun spec's;
Rock River AR 15
Bushnell Trophy red dot 1X
Well the problems then started, as my scope was a 1X and my eyes are 59 years old I could not see the black bullseyes on the target. Also the sun did not help as it was to my back and there was a glare from the white cardboard of the target. I shot 2 rounds, both were real low, could not be sure if it was the powder load or if I was not aiming correctly. So I packed it up and went home.
Will need to get bigger bullseyes and maybe do 2 target boards of 10 shots each, instead of one 20 target board. JLA will this cause any problems in reading the data from the targets? As I would need to go and switch targets after 10 shots. As always, thanks for any feedback.