From the experts at Sierra.
When we stop to consider the vigorous (read, downright violent) chambering cycle a loaded round endures in a Service Rifle, it becomes pretty clear it suffers abuse that would never happen in a bolt-action. This is simply the nature of the beast. It needs to be dealt with since there is no way around it.
There are two distinctly different forces that need to be considered: those that force the bullet deeper into the case, and those that pull it out of the case. When the round is stripped from the magazine and launched up the feed ramp, any resistance encountered by the bullet risks having it set back deeper into the case. Due to the abrupt stop the cartridge makes when the shoulder slams to a halt against the chamber, inertia dictates that the bullet will continue to move forward. This is exactly the same principle a kinetic bullet puller operates on, and it works within a chamber as well.
Some years ago, we decided to examine this phenomenon more closely. During tests here at Sierra’s range, we chambered a variety of factory Match ammunition in an AR-15 rifle. This ammunition was from one of the most popular brands in use today, loaded with Sierra’s 69 grain MatchKing bullet. To conduct the test, we chambered individual rounds by inserting them into the magazines and manually releasing the bolt. We then repeated the tests by loading two rounds into the magazine, chambering and firing the first, and then extracting and measuring the second round. This eliminated any potential variation caused by the difference between a bolt that had been released from an open position (first round in the magazine) and those subsequent rounds that were chambered by the normal semi-automatic operation of the rifle. Measuring the rounds before chambering and then re-measuring after they were carefully extracted resulted in an average increase of three thousandths (0.003") of forward bullet movement. Some individual rounds showed up to seven thousandths (0.007") movement. Please bear in mind that these results were with factory ammunition, normally having a higher bullet pull than handloaded ammunition.
To counteract this tendency, the semi-auto shooter is left with basically two options: applying a crimp or increasing neck tension.
Link to complete article.