RCBS Swager Issues
Recently picked up a RCBS Swager for my Rock River 223 since I buy Lake City Ammo. I installed the swager 223 plug inside the swager body and made sure it was good and tight and then mounted the swager assembly on my old RCBS C press. I then installed the stud and stripper on the ram and was getting ready to adjust the swager plug for the proper removal of the crimp. I went to slide the first piece of brass on the plug before running the press to the top of the stroke. I could not even get the brass inside on the swager plug in order that I could run the ram to the stop stroke to start the swaging process. Tried other brass and encountered the same issue. Does anyone have any ideas of what could be wrong?