|
![]() |
|
|
TheFirearmsForum.com
FOUNDED: February 9, 2001 |
If you prefer to make a donation by check,
send an email to Support for the mailing address. |
|
|
#1 |
|
Member
Join Date: Jul 2009
Posts: 2
|
I have four 7400 but they have different front sights. I need to remove the sights to replace with tru glo I can get the ones with dove tail but the others I have know clue any help would be great thanks wd9bob
-->
|
|
|
|
|
|
#2 |
|
Advanced Senior Member
Join Date: Feb 2007
Location: NW Florida
Posts: 8,661
|
Front sights are held on, to my knowledge, one of three different ways.
Dovetailed. You say you got that one figured out. Screwed. The barrel is drilled and tapped, and there are little screws at the front and back of the sight ramp, and it's just screwed down. Silver solder. The way to remove this one is to heat it until the solder melts.
__________________
Meddle not in the affairs of dragons, for thou art crunchy, and taste good with catsup - George of Lod, Year of Our Lord 297 I always take precautions. Beware the Evil Bullet Fairies.
|
|
|
|
|
|
#3 |
|
Advanced Senior Member
Join Date: Feb 2007
Location: NW Florida
Posts: 8,661
|
There's also staked, but I don't think that would be done on a rifle. Too much recoil.
__________________
Meddle not in the affairs of dragons, for thou art crunchy, and taste good with catsup - George of Lod, Year of Our Lord 297 I always take precautions. Beware the Evil Bullet Fairies.
|
|
|
|
![]() |
| Thread Tools | |
|
|