Need a stock and forend - The Firearms Forum

pyork2 · 06-01-2012, 11:36 PM

I have my grandfather's Harrington & Richardson Arms Co. Bay State 410 GA Choke shotgun, ser.# A197464. It also says Worcester Mass USA, made in USA. The stock and forend were damaged and I gave them to an aquaintance who said he could fix and/or build new ones. He decided to move without telling me and now stock and forend are in the wind. I have all the hardware, only gave him the wood. Now I am looking for replacements. Old or new, I don't care. The less expensive the better. Have searched the internet and found several hopeful sites but not able to nail it down. Apparently these numbers could refer to several different sizes of gun if I am reading the sites correctly. Found a schematic of a "148 early model" that looks to be the same gun but it is hard to tell for sure. Found a stock and forend listed at gunpartscorp.com under part # 706980 that may be the right ones but they were sold out. Any help is appreciated. Would love to get this gun whole again after so many years in parts. Thank you.

bntyhntr6975 · 06-02-2012, 01:44 AM

Check out Numerich. Most likely it's sold out, seems most wood is anymore. But it's worth a shot.

TRAP55 · 06-02-2012, 12:40 PM

http://www.gun-parts.com/harringtonrichardson/

https://www.macongunstocks.com/Custo..._Services.html

06-01-2012, 11:36 PM	#1
pyork2 Member Join Date: Jun 2012 Location: Broken Arrow, OK Posts: 1	Need a stock and forend I have my grandfather's Harrington & Richardson Arms Co. Bay State 410 GA Choke shotgun, ser.# A197464. It also says Worcester Mass USA, made in USA. The stock and forend were damaged and I gave them to an aquaintance who said he could fix and/or build new ones. He decided to move without telling me and now stock and forend are in the wind. I have all the hardware, only gave him the wood. Now I am looking for replacements. Old or new, I don't care. The less expensive the better. Have searched the internet and found several hopeful sites but not able to nail it down. Apparently these numbers could refer to several different sizes of gun if I am reading the sites correctly. Found a schematic of a "148 early model" that looks to be the same gun but it is hard to tell for sure. Found a stock and forend listed at gunpartscorp.com under part # 706980 that may be the right ones but they were sold out. Any help is appreciated. Would love to get this gun whole again after so many years in parts. Thank you. -->

06-02-2012, 01:44 AM	#2
bntyhntr6975 V.I.P. Member Join Date: May 2009 Location: Wichita, Ks. Posts: 296	Re: Need a stock and forend Check out Numerich. Most likely it's sold out, seems most wood is anymore. But it's worth a shot. __________________ There is a fine line between paranoid and prepared.

06-02-2012, 12:40 PM	#3
TRAP55 Advanced Senior Member Join Date: May 2004 Location: Occupied Territory Of Kalifornia Posts: 1,834	Re: Need a stock and forend http://www.gun-parts.com/harringtonrichardson/ https://www.macongunstocks.com/Custo..._Services.html __________________ Aim small...Miss small www.mausercentral.com/forum