|
![]() |
|
|
TheFirearmsForum.com
FOUNDED: February 9, 2001 |
If you prefer to make a donation by check,
send an email to Support for the mailing address. |
|
|
#1 |
|
V.I.P. Member
Join Date: Feb 2009
Posts: 56
|
Hi, I have a post 1894 5 shot 38/40 revolver made in belgium .It is patterned from a colt peacemaker.It is missing its cylinder stop and cyl stop spring.I did not get the missing parts with gun to copy .It is a different system than Colt and S/w inside because of pivot points and clearances.I have tried to make a few parts and I have not found the right solution as yet.The gun has 2 screws and a cross pin in frame close behind the cyl stop hole. The trigger and hammer using the screws.these are set in a different pattern than colt and S/W, and no screw hole under trigger guard to mount a cyl stop spring like Colt.I hope some one can set me in the right diection so I can make the parts that will work .It is probably some kind of European standard trigger system of that period. Thanks, Thunderace
-->
|
|
|
|
|
|
#2 |
|
Member
Join Date: Jul 2009
Posts: 13
|
I wish you had some pictures so I can see the stamps on it and try to ID for you..
Check here.. But it will take a while to figure out the site.. www.littlegun.be Andre
__________________
Winchester Model 88 Lever Action .308 cal. |
|
|
|
![]() |
| Thread Tools | |
|
|