H&R 903 - The Firearms Forum

badshotlal · 05-16-2009, 03:51 PM

Good day to all

Have a H&R Model 903 -- all steel, made in the U.S.A.--worth having just for that on the barrel!!
Trigger pull is just short of anvil weight. Finally hooked it up to a log chain, flagged an 18 wheeler down, and she went "pop"! Whew, it is hard!!

Any of you folks had trigger work done on that or similar models? Or, for that matter, know a good "trigger-smith" not backed up until our next life?
For these ole' eyes, aint' much light 'twix the front blade and rear notch. Not sure how to adjust the sight. Does that tiny screw, on the side, adjust the windage? The top screw -- much larger -- has witness marks. Assume it's for elevation.
Appreciate your input. Hope you and yours are well.

God Bless

Lloyd A. Leinmiller

05-16-2009, 03:51 PM	#1
badshotlal Member Join Date: Apr 2009 Location: Wichita, Ks. Posts: 14	H&R 903 Good day to all Have a H&R Model 903 -- all steel, made in the U.S.A.--worth having just for that on the barrel!! Trigger pull is just short of anvil weight. Finally hooked it up to a log chain, flagged an 18 wheeler down, and she went "pop"! Whew, it is hard!! Any of you folks had trigger work done on that or similar models? Or, for that matter, know a good "trigger-smith" not backed up until our next life? For these ole' eyes, aint' much light 'twix the front blade and rear notch. Not sure how to adjust the sight. Does that tiny screw, on the side, adjust the windage? The top screw -- much larger -- has witness marks. Assume it's for elevation. Appreciate your input. Hope you and yours are well. God Bless Lloyd A. Leinmiller -->