The Firearms Forum banner

.318 ( 8x57jr ) reload dies and brass question

3K views 0 replies 1 participant last post by  soundguy 
#1 ·
I may consider reloading for this.

currently i have regular 8mm mauser relaod dies ( 323 bore.. for the non rimmed cartridge / S bore.

I have 2 boxes of S&B 8x57 JRS that I can't figure out any other good uses.. was considering pulling the .323 projectiles and saving them for my 8mm mauser loads, and then resizing the cases once i locate a .318 8mm JR die, etc.

anyone see a problem with this? I'll mic the necks after laoding.. might have to id ream?

anyone relaoding for the 8x57 JR and what die sets are you using?

What projectiles have you used?

thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top