.44 mag lee dies

Discussion in 'The Ammo & Reloading Forum' started by kar298, May 7, 2004.

  1. kar298

    kar298 New Member

    Joined:
    Mar 22, 2004
    Messages:
    180
    Location:
    johnstown, pa
  2. inplanotx

    inplanotx New Member

    Joined:
    Jan 28, 2002
    Messages:
    8,889
    Location:
    Texas
    Click on your URL and then click on "technical specification and use". Your answer is right there on the last line.
  3. kar298

    kar298 New Member

    Joined:
    Mar 22, 2004
    Messages:
    180
    Location:
    johnstown, pa
    yeah i says that you can change the crimp but it didnt say anything about a crimper die so i wasnt sure if it was a miss print
  4. inplanotx

    inplanotx New Member

    Joined:
    Jan 28, 2002
    Messages:
    8,889
    Location:
    Texas
    The crimper is part of the seater die!
    Last edited: May 7, 2004
  5. kar298

    kar298 New Member

    Joined:
    Mar 22, 2004
    Messages:
    180
    Location:
    johnstown, pa
    ok thats what i though i just wanted to make sure i just put my order in for some stuff
Similar Threads
Forum Title Date
The Ammo & Reloading Forum Reloading .38 (short case) with .380 dies? Jun 26, 2014
The Ammo & Reloading Forum .40-70 Ballard brass and dies May 8, 2014
The Ammo & Reloading Forum Inline Fabrication goodies Mar 22, 2014
The Ammo & Reloading Forum Anyone load 327 Fed Mag using 32 H&R Mag dies Mar 13, 2014
The Ammo & Reloading Forum 9mm dies for 380? Mar 7, 2014

Share This Page