Got my Rockcrusher!!! Tips welcome.

Discussion in 'The Ammo & Reloading Forum' started by WildcatFan, Dec 25, 2009.

  1. WildcatFan

    WildcatFan New Member

    68
    Aug 1, 2009
    St. Louis
    With RCBS 3-die set for my .45 ACP. Any tips for setup of dies that's not covered in the manual. Pointers, etc?


    I'm thinking of bolting my powder charger to the left of my press, about a foot. How do y'all have it set up? Any and all does and don'ts are welcome.

    Merry Christmas, ya'll.
    Alex
     
  2. myg30

    myg30 Member

    41
    Mar 12, 2009
    Nash,TN.
    I have my powder measure bolted to a seperate board 3/4" ply. Clamp it to the bench when needed. Off the bench when doing trimming etc.. I have a small reloading bench.
     

Similar Threads
Forum Title Date
The Ammo & Reloading Forum Scale and Powder Thrower accuracy tips Mar 10, 2016
The Ammo & Reloading Forum Hornady TECH TIPS: Setting up a Pistol Taper Crimp Seater Die Feb 9, 2016
The Ammo & Reloading Forum Nasty Brass Cleaning Tips Mar 13, 2014
The Ammo & Reloading Forum reloading pulled red/green tips components Feb 12, 2013
The Ammo & Reloading Forum A couple of tips to check for scale problems Nov 3, 2012