The Firearms Forum banner

Iver Johnson 2nd model 32 hammerless

1K views 5 replies 4 participants last post by  dpcjradio 
#1 · (Edited)
I need to make and install the spring for the hand but don't know what it looks like or how it goes. Anyone have a pic of the spring and a pic of it installed on the trigger//hand/blocking bar assembly? Also, is this the spring Numrich calls a "lever spring"? Any help would be appreciated. Is this spring the same for the 3rd model?
 
#5 ·
If you purchase one from Nurmich, it will come with a picture to help you. There is a long side / short side, and a loop at the bottom that goes on the pin between the hand and the lifter. I think the long side goes against the back of the hand and the short side goes against the lifter.

I had to trim a little off the spring on the hand side because too wide and dragging on the inside of the frame. If you have the same problem, be careful not to take off too much because it will slip off the hand.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top