The Firearms Forum banner

Iver Johnson 3rd model hammerless

459 views 1 reply 1 participant last post by  tomsp8 
#1 ·
Hello all
I have a 1910 production Safety Hammerless in need of a hammer lifter. The one in mine broke in
half above the hammer notch, and appears to have been brazed/fabricated at some point in it's
life. I have had no luck thus far finding one, scouring the web and calling old parts houses for several weeks.
Attempting to make one out of bar steel (and case harden it afterwards). Does anyone have one out of an old parts gun, or maybe have a really good picture of one I can use for reference in making a replacement?
If someone happens to have one disassembled, maybe a couple good pictures of the part with some
measurements of key areas?
This gun has no real value based on overall finish condition, but belonged to a longtime coworker, was his fathers, and would like to repair it to function in his honor.
Thanks!
Tom
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top