Need "Hopkins & Allen" revolver parts

Discussion in 'Curio & Relics Forum' started by robertscheib, Jan 12, 2011.

  1. robertscheib

    robertscheib New Member

    Joined:
    May 6, 2009
    Messages:
    15
    Location:
    Kennewick, WA
    I need two parts for a "Hopkins & Allen XL Double Action" pocket revolver - this is a 5 shot, .32 S&W cal. I need a "Lever" and "Lever Spring"- see parts #14 and #18 on attached illustration.
    Would be willing to buy a junk frame with trigger and hammer parts intact if necessary.
    I'd appreciate any contact info for parts sources: I know about NUMRICH, BOB'S GUN PARTS - others?
    "robert.scheib1@frontier.com"

    Attached Files:

    Last edited: Jan 13, 2011
  2. Jim K

    Jim K New Member

    Joined:
    Dec 6, 2009
    Messages:
    6,400
    Those parts should be fairly easy to make, but that would not be cheap.

    Just FWIW, that spring is made with the loop because it powers not only the hand but also the lifter (13) which is shown backwards. In use, its point goes to the rear to engage the strut (15, which is shown upside down) and the loop in the spring pushes on the bottom of the lifter to force it to the rear.

    Jim
  3. robertscheib

    robertscheib New Member

    Joined:
    May 6, 2009
    Messages:
    15
    Location:
    Kennewick, WA
    Jim,
    I appreciate your comments - and you are right as to parts orientation.
    a gentleman on another forum has offered to sell me two complete "junk" guns [cheap!!] for parts salvage.
Similar Threads
Forum Title Date
Curio & Relics Forum Need help in ID'ing this piece. Nov 13, 2013
Curio & Relics Forum Need help with ID Nov 11, 2013
Curio & Relics Forum Info needed: Nagoya Series 5 Type 99 May 30, 2013
Curio & Relics Forum more ?'s / opinion needed on metal paint on sks May 21, 2013
Curio & Relics Forum Need help identifying markings on a Ketland flintlock pistol Feb 19, 2013