Savage 24

Discussion in 'Technical Questions & Information' started by BRSmith, May 24, 2012.

  1. BRSmith

    BRSmith Member

    Joined:
    Nov 24, 2007
    Messages:
    273
    Location:
    Minnesota
    Went to use dads model 24 yesterday for some pest control. this has not been used for some time, probably 3 years. The darn thing didn't fire on either barrel. Anyone have any suggestions as to the problem? LGS says the firing pins seem to be moving.
  2. luv2weld

    luv2weld New Member

    Joined:
    Feb 29, 2012
    Messages:
    20
    Location:
    Central Colorado 9600 feet elevation
    Work the barrel selector back and forth several times to make sure it isn't hanging up in the middle.
    Check the primers to make sure the firing pins are moving.
    Visible signs of rust in the mechanism???
    Spray CRC or WD-40 into mechanism and work barrel selector again.

    Ralph
  3. Gabob

    Gabob Well-Known Member

    Joined:
    Dec 5, 2005
    Messages:
    1,383
    Location:
    SW GA CSA
    Don't know what version of the Model 24 you have. The older ones had a button on the side that moved a transfer block in back of selected firing pin. I had one of those break and hammer does not meet firing pin. Newer ones have selector on the hammer.
Similar Threads
Forum Title Date
Technical Questions & Information savage model 1907 Yesterday at 12:54 PM
Technical Questions & Information Slide assembly compatibility - Savage Model 30 to Hiawatha VR130 12 ga pump Saturday at 3:04 PM
Technical Questions & Information savage 775 A bolt sticking Jul 5, 2014
Technical Questions & Information Savage 110ML Jun 5, 2014
Technical Questions & Information Savage Model 87A mag guide May 20, 2014

Share This Page