Scope rings. CZ 452 special

Discussion in 'Technical Questions & Information' started by da357mag, Jan 5, 2010.

  1. da357mag

    da357mag New Member

    Joined:
    Sep 26, 2009
    Messages:
    238
    I have a 452 special I tried to put a scope on last night, the rings I have
    are B-square high rings, 11mm dovetail base, they measure .750 from the
    reciever base to the bottom of the scope base itself. the scope is a
    centerpoint 4-16x40mm AO scope I decided to try on a recomendation. With
    the bases on the scope sits on the rear sight base (I removed the rear sight)
    and needs about 1/8th of an inch to clear the sight base. I have thought about "shimming" the scope to raise it slightly but I dont know what this
    would do to the accuracey of the rifle, it dosn't sound like a good idea to me.
    I was told about Barska rings and there "very high" rings and found them
    on a site called optics planet. net, they are inexpensive and do look higher
    but I have heard good and bad about Barska products, and nothing about
    there scope rings. There site hsd no measurements on the ringe and did not
    say if they were 3/8ths or 11mm. does anyone know about these rings? and
    if not any ideas as to what I could use would be welcome. thanks in advance
    Doug, DA357:confused:
Similar Threads
Forum Title Date
Technical Questions & Information Scope Rings for Thompson Center Venture - which ones? Sep 21, 2013
Technical Questions & Information Bad scope or scope rings or ??? Oct 15, 2011
Technical Questions & Information Mark III Hunter Scope Rings Oct 13, 2011
Technical Questions & Information Scope slipping in the rings? Nov 10, 2010
Technical Questions & Information What scope/rings/base to use with my rifle? Oct 19, 2010