The Firearms Forum banner

case

  1. First Shotgun - New to the game

    Large-Bore/Small-Bore Rifle/Shotgun
    Well after 32 years on this earth my Father finally took me out shooting. The old man has 5 shotguns and never took me out when I was younger! We went clay shooting and I immediately became addicted and needed to buy my own firearm. We then went quail hunting and it was a blast! I found a great...
  2. The Ultimate Guide to Case Reforming

    The Ammo & Reloading Forum
    Reforming a case is literally to change a case from it’s designed caliber and profile into a different profile or caliber. If you have read some of my other articles on reloading or lead casting, you may have noticed that when describing some procedures that I will say that some are left to...
  3. .243 reloading issue

    The Ammo & Reloading Forum
    Hi guys, I have had some cases reloaded by my father for my .243 and they have been tight when trying to close the bolt. the cases are once fired factory and did not get tight at all, cycles as it should. they were 90grain bullets, I have reloaded them with a 70grain bullet. all of the reloaded...
  4. Browning Challenger II Case Ejection Issue

    .22-Rimfire Forum
    Hi everybody, Yesterday I picked up this beauty, vintage 1977, for a mere $350. The guy wanted more but I talked him down because he was moving to an anti-gun country the same week. Anyway, I cleaned it up (there wasn't much cleaning to be done, hadn't been used in years), got her oiled, took...
Top