The Firearms Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
5,181 Posts
It shouldn't be a problem, the .45ACP is a low pressure round that most likely isn't going to bulge the cases even if shot in the unsupported glock chamber. Run the brass through your sizer die and look for signs of case bulging, if not present use it as any other brass that you may have. If it is slightly bulged, Lee and Redding make a die that will remove the bulge and allow proper chambering.

those who beat their guns into plowshares, will plow for those who didn't
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top