The Firearms Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter #1
I have not been able to remove the ejector rod from this firearm. I have smithed Pythons before but never had to repair this part. I have read several post about doing this but I cant seem to make any progress for fear of breaking something. Any expertise would be greatly appreciated.
 

·
Registered
Joined
·
46 Posts
Discussion Starter #3
Can you elaborate? I haven't seen the nut you refer to. Is this at the front of the cylinder? The only Python diagram I have seen doesn't show this part.
 

·
Registered
Joined
·
46 Posts
Discussion Starter #6
Yes, I've seen this. My problem is I cant remove the ejector "star" at the back of the cylinder.
 

·
Registered
Joined
·
46 Posts
Discussion Starter #8
I thank you for that. Only problem is that it will not unscrew. That is why I mentioned in the beginning that I was nervous about damaging the assembly.
 
1 - 8 of 8 Posts
Top