The Firearms Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6,379 Posts
I am not sure that technique works with any material much thicker than the sheet steel shown there. EDM and plasma cutters will work with thick metal, but other methods are usually as good or better (or cheaper) for mass production.

Jim
 

·
Registered
Joined
·
71 Posts
Discussion Starter #3
Jim im show easy technical for repair and plasma cutting , die maker ..... Not for anyone
i need 8 hours maybe more for build die, whit this technical i can try some configuration in short time... Lot s weapon no have part in market , i think is good trick... That work for thinker mutch of 1/8 but not whit this configuration.... Alum dont work....

Martin
 
1 - 3 of 3 Posts
Top