The Firearms Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
563 Posts
Discussion Starter · #1 ·
I engraved a standard walnut stock (factory finish) and would like some advice/opinions on what would be the best way to refinish it. I engraved the P.O.W.-M.I.A. Logo and can't decide on what would look best for a finish on it without going overboard. Should I burn the edges, black it, stain it, two-tone stain it or just lacquer it since its lighter than the factory finish. Any help/opinions would be appreciated. Also if there is anything you see wrong with the work please let me know as I am new to stock work and would appreciate any tips/tricks you gentlemen have. :) (Please keep in mind I am not finished with the engraving itself so it's still a little rough.)
 

Attachments

·
Registered
Joined
·
563 Posts
Discussion Starter · #2 ·
I apologize in advance, I forgot to resize the picture... Realized it right after I clicked 'submit'.
 
1 - 2 of 2 Posts
Top