The Firearms Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
761 Posts
Discussion Starter · #1 ·
Hey I just went to the range today and shot my 9mm lead cast bullets. I'm using a 124gr RN bullet and 4.0 grs of Tight group with a CCI 500 primer and my OAL is 1.135" I'm shooting my ruger p95 and my son was using his Taurus PT 92. All shot good and cycled real good the question I have is my shells had a good amount of soot on them. And when my son was shooting I noticed what seemed like a good amount of smoke with every shot. He said the same with my gun too. So does the sooty shells mean I have to crimp more? And what about the smoke? Am I doing something wrong?
 

·
Registered
Joined
·
761 Posts
Discussion Starter · #3 · (Edited)
Well according to my manual 4.0grs of TG is the max load. My accuracy was good.
 

·
Registered
Joined
·
761 Posts
Discussion Starter · #5 ·
They were store bought bullets. And the seating, I only made a few at 1.125" cuz when I posted my bullets for comment a few guys said I needed to leave a bit more bullet to crimp. So I seated it just a bit less to crimp better. But I'll try the 1.125" again to see how they shoot. And yeah the soot just came right off when I cleaned them. I just thought it may have been a sign of something badly done. But as far as the bullet shot it was good accuracy and ran thru the gun good, so I just had that soot thing as bad. But thanks for the comments they are always welcome.
 

·
Registered
Joined
·
761 Posts
Discussion Starter · #7 ·
O ok. That's good then. It doesn't bother me just thought there might be a problem. So it's all good, won't give it too much thought. Thanks.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top