The Firearms Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
I have an H&R922 that is the marking on the barrel. No space between the R and the 9. The serial number listed on the butt stock is "R 3941" I am not sure the gun is safe to fire because :

1) the rod the under the barrel that is used to release the cylinder Had nothing to hold it in place except black electrical tape.
 

·
Registered
Joined
·
5,284 Posts
I would get that fixed before firing it, but the cylinder should lock in place with the hammer cocked. have you tried this to see if it locks?

welcome to TFF too! I have a 922 and shoot it on most every trip to the range. Good little guns.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top