[Sourdough3]

Have installed a Dakota 3 position safety/timney featherweight trigger on a M98 receiver and followed manufacturers install instructions. Problem is bolt won't cycle in the second safety position, bolt will cam up 90 degrees but won't open to remove bullets, etc, and am totally stumped as to why, safety/bolt work as intended in fire and full safety positions, anybody know how to resolve please? Thanks

 

[Sourdough3]

Bindernut appreciate your reply, I'm thinking the trigger is the culprit too, will apply some layout dye in the morn and see about any binding, have removed the trigger and there's no binding of any kind, don't have a previous trigger didn't come with receiver, if I can't figure out I'll send to my gunsmith, can't believe it's that complicated though. Regards