The Firearms Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
75 Posts
Discussion Starter · #1 ·
Hello
I notice when I pull the slide back about half way it becomes tight as if it is grinding along the rails & then gets smooth past that point. Anyone have this with their Colt Mustang? Regards
 

·
Registered
Joined
·
3,725 Posts
Depends on exactly were the slide is when it binds. Could be the hammer dragging on the back of the slide when its cocking, could be a bound recoil spring or your extractor is binding up on the side of the slide.
 

·
Registered
Joined
·
75 Posts
Discussion Starter · #3 · (Edited)
I think it is the extractor or the ejector. I am going to buy a replacement & see if thats the problem. Thanks
 
1 - 3 of 3 Posts
Top