The Firearms Forum banner
1 - 1 of 1 Posts

· Registered
1,684 Posts
Discussion Starter · #1 ·
Posts: 38
(12/2/02 7:11:59 pm)
Reply | Edit | Del All Laminated SKS stocks
Have any of ya'll ever refinished a laminated stock. I just bought one, and it's in bad shape. Beautiful wood, but bad coating. So far I have used ZIP-STRIP to remove the old finish, and a coat of Blip seal on one side. I was just wandering if any of ya'll have ever tried this before and what you used. Thanks

Bob In St Louis
*TFF Senior Staff*
Posts: 3358
(12/2/02 8:31:38 pm)
Reply | Edit | Del Re: Laminated SKS stocks
Actually, I have refinished several of these in the same maner as a regular hardwood stock - working down through a series of grit papers, finally OO steel wool, boiled linseed oil coats, and polish with OOOO steel wool. The laminates I refinished actually sanded faster than regular hardwood.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.