The Firearms Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Hi

Have a new locking bar to fit to my 1100 LW 410 model and find there is a locking screw on one side

Having newver taken the bar out I am looking for assistance, I think i just take out the retaining pin for the firing pin, then remove both fireing pin and spring and the bar should fall out

This begs the question what is the locking screw for and does it screw tight against something if so what

Prefer to be fully aware of what i am doing beofre taking the block apart

Many thanks if you can help
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top