The Firearms Forum banner
1 - 1 of 1 Posts

· Registered
450 Posts
Discussion Starter · #1 ·
I need some help. The extractor is loose on my pistol. I ordered a replacement and I got it a couple days ago. Looking at it, it appears to be the wrong part. The slot where the extractor fits into the slide, looks to be too small for the replacement part.

Question is, is this a press to fit part? I really dont see what is holding the extractor in the slide other than that its pressed into the slide. If not, then how does the extractor come out? I have tried to find out on the net, but no luck.

Should I just send it to a gunsmith, or is this something an average joe can do?

I am fairly technical and am pretty handy when it comes to working on things, but this has me stumped.

Its chambered in 357 Sig if that makes any difference.

Thanks for any Help,

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.