The Firearms Forum banner
1 - 4 of 4 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Hello, this is my first time here so I'm unsure if this is the correct place to ask this. I was given an old SKS that at the time would not fire. i spent about 3-4 hours cleaning it and freed the firing pin. now that i works / firers like a dream i have been updating some of the parts: stock, spring, gas tube, and piston.
one think i have seen little of is the rear bolt / dust /spring cover. the one currently on it is trashed and has grinder markings and just dose not look good. i cant seem to locate a original looking cover for it. no rail just clean. any ideas?

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.