The Firearms Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have an older pre-ban Intratec Scorpion 22......ordered a firing pin from sks....fine, When I got the extractor kit ,they were totaly different....would have tried it(maybe an upgrade?) but the spring would not fit in the bolt......Original was.122,replacement was .133.It is supposed to be of a lot of 10/22 parts.......anyone run into this The initial problem was "stove piping" Not a problem 20 yrs ago,when I last shot it.....actually "quite loose" LOL feathering was never a problem with good ammo .:)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top