[Phragus]

I have found that the bullet seater supplied with my RCBS set is not long enough to properly seat the bullets. I think it is the sharp point on the bullet that makes it make contact with the seater at a much lower point on the bullet. Does RCBS make a seater for this bullet? I asked Hornady and they blew me off and told me to talk to RCBS.

Has anyone else had this problem?

 

[Skipper]

Check with RCBS:

http://www.rcbs.com/general/ask.aspx

Mail Address:
RCBS Operations
605 Oro Dam Blvd
Oroville, CA 95965
1-800-533-5000
email: [email protected]

 

[oneoldsap]

If you have .308 or 30-06 dies , use the seating plug from one of those . The 30-30 seating plug is for a flat or round nosed bullet . At least I think that might be a remedy !

 

[USMCSpeedy]

If you have .308 or 30-06 dies , use the seating plug from one of those . The 30-30 seating plug is for a flat or round nosed bullet . At least I think that might be a remedy !

I was going to recommend the same thing. I use my 38/357 wad cutter seater to seat 147g XTPs in 9mm.