The Firearms Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
761 Posts
Discussion Starter #1
Hey does anyone have any load data for wsf powder. I wanna use a hornady 124xtphp bullet? I only have a couple of load guides and the only wsf powder data uses a 124 fmj or lead cast. So I was wondering if anyone had wsf data for that bullet. I'm using a cci 500 primer. And fc brass & Winchester brass.
 

·
Registered
Joined
·
685 Posts
Winchester Powder load data from their website says 4.7 start, 5.3 max for WSF under a 124g FMJ. 8th Hornady manual doesn't list for WSF but uses the same data for the fmj and xtp on all their powders listed.
 

·
Super Moderator
Joined
·
41,401 Posts
You forgot to mention what caliber you are loading for. I am assuming that it is 9mm but it could be anything.

No offense intended, but I know that no one would give you wrong information on any loads. What would happen if I made a typographical error when I typed the powder information and you followed it and got hurt. Just about all of the major powder manufacturers have web sites that give load info. I'm not saying that they can't also make an error....but, I'm just saying.

Suppose I typed in that my greatest load is 7.4 grains of WSF, instead of what I really meant to be 4.7 grains.
 

·
Registered
Joined
·
761 Posts
Discussion Starter #4
Yes it's 9mm. Thanks
 
1 - 4 of 4 Posts
Top